salar

I have had a Yanmar for the last ten years and it's been very reliable. A lot of parts have aftermarket non-Yanmar alternatives although...

This is massively helpful. Will be checking it out when I'm next on the boat on Friday.

登录 Facebook "Sitting there rotting in a boatyard" and others

My Yanmar is a different model but similar design. Have a look behind what you have shown, mine is accessed from the side of the engine...

Thanks folks. That's made my mind up. I'll use a substantial connector to a short extension and leave the stud out. I've already moved...

I have done exactly that, and used a copper tube butt splice connector like so Copper Tube Butt Splice Connector for 16mm² Cable covered...

Being a cheap skate ... if its a recess and not through the hull - I would use your auto filler ... first of all getting surface really...

Another vote for steaming. Many years ago I renovated a few gunstocks and we raised dents with the steam method. You may have to do it...

In my experience each manufacturer has a different valve. Most yacht chandlers sell a little plastic bag containing several different...

I had the same problem, and it being a fishing boat I have lots of sensitive plotters and things. The reset is caused by a voltage drop...

Look on ebay. Hit and miss but there are often offcuts of stainless steel of various thicknesses and sizes. I used a 30cm x 15 cm piece...

The larger the backing plate, the more you will spread the load so I would glass in a ply backing plate a good bit larger than the...

Try telling that to the runs under my rail cappings that I didn’t notice for a week or so.

Here's a table I made, finished in satin Epiphanes. This is the original build photo, and it has seen service for the past 10 years and...

Two not mentioned so far: WD-40, good for removing sticker glue, and meths, which I have found is sometimes the only solvent that will...